Snapmaker U1: 10+ colours without an AMS, here's how
A toolchanger can go past the limits of an AMS. How to set up a print with more than ten colours, and what it costs you in time and attention.
With four filaments loaded you can print ten colours and more, with no AMS and no additional automatic changing system. It isn’t a trick: it’s a feature of the beta build of Orca Slicer optimised for Snapmaker.
How it’s possible
The insight is separating two things that usually get conflated: how many filaments are loaded and how many colours appear in the finished part.
A print doesn’t use every colour simultaneously through its full height. Many multicolour models use one group of colours in the lower layers and a different group further up. If the slicer knows at which point a colour stops being needed, it can schedule a manual spool swap at exactly that moment, freeing a head for a new colour.
Four heads become four reusable slots along the Z axis, rather than four fixed colours.
What you need
- The Snapmaker-optimised beta build of Orca Slicer, from the releases page: OrcaSlicer FullSpectrum
- A Snapmaker U1 with all four heads
- The filaments you intend to use, ready for a swap on the fly
The advantage over an AMS
An AMS reaches many colours but pays a toll on every single change: purging the nozzle. Here the colour changes during the print are still tool changes, so there’s no purge; the only extra work is swapping a spool by hand at the planned points.
In practice: more colours, the same waste as before, in exchange for a few minutes of your presence.
Limits to know before you try it
It’s a beta, and it behaves like one. Budget for three constraints:
- You have to be there when the spool swap comes up. A ten-hour print with three scheduled swaps is not a print you start and then go out.
- The model has to suit it. If all ten colours are spread across the full height, the technique doesn’t apply: you need separation along Z.
- It’s beta software. The usual rule stands: don’t use it for a long print you can’t afford to lose, until you’ve found your feet on something small.
Disclosure: the purchase links below are affiliate links. If you use them I receive a
small commission and you pay no more.
Snapmaker U1 on the official site
— €20 discount code: waltermaker20 · 5% discount code:
walter_esposito-1-1.
